Latest Articles

TORQUE CONVERTER INSTALLATION Tools Required

{ No Comment }

J 21366 Converter Holding Strap Installation Procedure CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly. Fig. 472: View Of J 21366 Installed On Torque Converter Courtesy of GENERAL MOTORS CORP. 1. Install the torque converter. 2. Install the J 21366 .

TORQUE CONVERTER END PLAY INSPECTION Tools Required

{ No Comment }

• J 8001 Dial Indicator Set • J 26900-13 Magnetic Indicator Base • J 35138 Converter End Play Checker. See Special Tools. • J 39195 Converter End Play Check Tool. See Special Tools. Inspection procedure Fig. 471: Identifying J 35138, J 26900-13 & J 8001 Courtesy of GENERAL MOTORS CORP. 1. Inspect the torque converter […]

TRANSMISSION FLUID PAN INSTALLATION

{ No Comment }

Fig. 460: View Of Transmission Oil Pan & Gasket Courtesy of GENERAL MOTORS CORP. 1. Place the transmission oil pan gasket (73) on the case. 2. Place the transmission oil pan (75) on the case. NOTE: Refer to FASTENER NOTICE. 3. Install all of the transmission oil pan screws (76). Tighten: Tighten the screws to […]

OIL FILTER ASSEMBLY INSTALLATION

{ No Comment }

Fig. 458: Locating Oil Filter Seal Courtesy of GENERAL MOTORS CORP. 2. Use a socket the same size diameter as the filter seal (71) and install the seal. Fig. 459: View Of Transmission Oil Filter Assembly Courtesy of GENERAL MOTORS CORP. 3. Install the transmission oil filter assembly (72).

CONTROL VALVE BODY INSTALLATION Tools Required

{ No Comment }

• J 25025-5 Dial Indicator Mounting Post-M6 x 1. See Special Tools.00 • J 36850 Transjel Lubricant Installation Procedure I________________ J Fig. 447: Identifying Secondary Fluid Pump Connector Courtesy of GENERAL MOTORS CORP. IMPORTANT: Secondary fluid pump connector (1) is used for M33 models only, connector (2) is used on ISS models. 1. Inspect the […]

2 ACCUMULATOR ASSEMBLE

{ No Comment }

Fig. 439: Locating Accumulator Piston & Oil Seal Ring Courtesy of GENERAL MOTORS CORP. 1. Inspect the 1-2 accumulator piston (56) for the following conditions: • Porosity • Cracks • Scoring • Nicks and Scratches 2. Install a 1-2 accumulator piston oil seal ring (55) on the 1-2 accumulator piston (56). Fig. 440: Locating 1-2 […]